For Yamaha Immobiliser Emulator 2002 - 2021 R1 R6 MT07 MT09 MT10 TMAX XMAX++Report Item / Suspicious ActivityCompatible 2002 - 2021 For Yamaha models: YZF R1 / YZF R6 FZ6N / FZ6S XJ6 T-MAX X-MAX V-MAX MT03, MT07, MT09, MT10 MAJESTY 400 XSR700 XSR900This new version has had a redesign with the following:Mechelectrics Custom Firmware - Exclusive firmware allows this to work on the widest range of modelsReduced Power Consumption - Less current drawn from battery in standbyHigher rated capacitors - No chance of emulator blowing capacitors as with the older designsDual layered PCB - Reduced corrosion when used in damp / wet conditionsCompact Design - No messy long wires30% Smaller PCB - New design has reduced size and weight compared to old versionsWater resistant casing - Sealed unit so no water ingressThis item is designed for the following purposes:Swap engines which no longer work with existing immobiliser unit (they are paired to engine ECU)Enable users to remove immobiliser units due to theft damage / recoveryEnable users to avoid high charges from For Yamaha dealer for replacing matched immobiliser / ECU unitProject bikes using For Yamaha engine / ECU but no immobiliser (track day safety requirements)Fault finding by omitting the immobiliser as source of starting issuesThis new 6 wire version has the highest chance of compatibility as it uses the full manufacturer wiring schematic which also keeps the immobiliser dash LED functioning (varies depending on model).Custom firmware flashed in house by Mechelectics to ensure this is the most widely compatible emulator on the market!Fitting Instructions(1) Simply trace your wiring from your key barrel transponder back to your ECU (usually under the fuel tank or headlight)2) Unplug and plug in the 'Plug and Play' emulator.3) You can now start your vehicle without transponder in the key