Smart Plug 2.4G WiFi APP Voice Control 433MHz Wireless Switch Delay Timing for Google Assistant Material: ABS Battery: 1PCS 12V 23A battery (NOT included) Quiescent Current: 8mA Rated Current: Maximum 10A WiFi: IEEE 802.11.b/g/n Use APP: For TUYA / for Smart Life Voice Control: Support for Home, for Tmall Genie, etc. Working Frequency: Remote Control 433.92MHz, WiFi 2.4G Load Power: 2200W Receiving Sensitivity: -105dbm Coding Method: Learning Type Working Mode: Self-locking, interlocking, timing, delay Modulation Method: ASK Control Distance: APP has no distance limit, remote control is approx. 100m/109yd (open area without interference) How e: Pairing Method: The socket has only one button, which is both the power button (manual switch) and the pairing button (remote control + APP). How to Pair APP Mode: Turn on the power, press and hold the pairing button for 5 seconds; the blue indicator light starts to flash slowly, indicating that you are waiting for pairing, then open the for TUYA APP and search for the device. When pairing for the first time, put the phone, switch and router as close as possible, about 15s will show that the pairing is successful, at this time the blue light is normally on, you can rename the device. Enter the APP page to set the scene and location. The switch is off by default, if you want to make changes, you can enter the Restart State Settings of the APP, and you can choose Power Off, Power On or Power Off Memory. How to Pair the Remote Control Mode: Turn on the power, press the pairing button, the red light is on, indicating that the output circuit is connected; press it again, the red light is off, indicating that the output circuit is off. Press the pairing button 8 times continuously, the red light flashes, indicating that the code is cleared successfully. When the output circuit is disconnected, press the pairing button twice, the red light turns on, and then press the remote control button, the red light flashes 3 times quickly, and the self-locking mode is set successfully. When the output circuit is disconnected, press the pairing button 3 times, the red light is on, press the A and B buttons of the remote control respectively, and the interlock mode is set successfully (ie A is on and B is off) Explanation of Output Mode: 1. Self-Locking: Press the same remote control button, press it once, the relay is turned on, and press it again, the relay is turned off. 2. Interlock: Press the A button on the remote control to turn on the relay, and press the B button on the remote control to turn off the relay.