Replacement clamp collar with ORing for 10 inch sand filter pump systems. Designed to match original dimensions for a secure, leakresistant seal and straightforward replacement. Key benefits Precise fit: made to the same specifications as the original clamp collar for 10 inch sand filter pumps and compatible with Intex SF901101 model. Verify your pump model before ordering to ensure proper fit. Complete replacement kit: includes 1 clamp collar, 2 stainless steel nuts, 2 stainless steel bolts, 2 rubber covers, and 1 ORing so you have all parts needed for a direct swap. Durable construction: molded plastic collar combined with metal fasteners and rubber components provides reliable assembly for routine pool use and exposure to pool water chemicals. Simple installation: hardware included and approximately 3.15 inch screws allow quick replacement without special tools or professional help. Reliable sealing: ORing and rubber covers help maintain a tight connection to reduce leakage and pressure loss in the filtration loop. Specifications and materials Compatible model: SF901101 Contents: 1 clamp collar, 1 ORing, 2 stainless steel nuts, 2 stainless steel bolts, 2 rubber covers Fastener length: approximately 3.15 inches Materials: plastic collar, stainless steel nuts and bolts, rubber ORing and covers Practical uses a worn or cracked clamp collar that is causing leaks or reduced pump pressure. Perform seasonal maintenance or preopening checks to ensure the sand filter pump is sealed and ready for use. or rebuild a pump after winter storage or accidental damage where the original clamp hardware is missing or corroded. Installation tip Remove the old collar, seat the ORing in the groove, align the collar halves, insert the bolts and tighten evenly until snug. Check for leaks after reassembly and run the pump briefly to confirm proper sealing. This replacement kit provides the parts and fit needed to restore proper sealing and function to compatible 10 inch sand filter pump systems.