1、Using stable and durable JMS583 high-level master control, built-in large-capacity ROM, can be personalized to customize the firmware and standby time 2、More than 20 processes such as CNC accuracy carving, polishing, sandblasting anode, etc., using double screws to fix the PCBA to avoid poor contact caused by loosening when plugging, so that the product is more durable and the data is safer; at the same time, it also avoids to reduce the heat conduction efficiency of the thermally conductive silicon wafer due to loosening 3、Just be fast, adopt 10Gbps USB3.1 GEN2 TYPE-C design, realize high speed transmission 4、Stainless steel CD pattern screws, possess good hardness, no rust, even disassembled many times, not easy to scratch, beautiful and shiny, and durable for several years 5、Highly flexible connectors, stable, anti-drop, as far as possible to protect your data security, we know that data is priceless like you 6、Continuous reading and writing can not be dropped, using high‑power DC chip, one‑piece inductance, bring higher conversion rate, stronger resistance to high and low temperatures, and of course more stable data transmission 7、The non-slip silicone ring reduces the interruption of data transmission caused by sliding, and can also bundle the data cable, making it more portable 8、Accurate heat conduction, distribution of 10 high-efficiency thermally conductive silicon wafers 9、Multiple protection contain over current protection, over voltage protection, leakage protection and short circuit protection 10、Contact‑type close‑fitting heat dissipation, using high‑conductivity phase‑change silicon chip and outer box heat dissipation aluminum contact type heat dissipation, allowing the main control and disc heat source to be directly conducted through the aluminum block for heat dissipation, fast and efficient, and ensure your data security Item Type: Mobile M.2 Hard Drive Enclosure Model: i9Plus Support: PCIE NVME protocol M.2 solid state drive(M.2 solid state drives that do not support SATA protocol) How to Use: 1. Unscrew the screw and open the sliding cover 2. Take out the copper bar 3. The hard disk (not included) is pasted with heat sink silicon 4. Insert the hard disk (not included) and tighten the screws to fix it 5. Install the hard disk box, screw on the screws, and close the box cover 6. Fix the box cover with screws 7. Insert the Type-C cable and connect to the computer to use 1 x Hard Disk Box(without hard disk) 1 x Type-C Line 1 x Screwdriver 1 x Rubber Ring 10 x Heat Sink 1 x Screw 1 x Nut