√ Pilot RF433Mhz. use in use No wiring required, it is installed with UE and France standards, simple configuration parameters. Easy remote control √ 16A High Power Discover the power of a variety of home appliances that are safe to use. When the power is off, turn on again, the state of the device is disconnected. √ Stable signal, long control distance Powerful chip, signal can pass through the wall, effective distance from the network can be 30-60 meters, and effective outdoor scene can be 150 meters. √ Supports flexible pairing It is not possible to use several in the same room. One socket can be stably paired with up to 30 connected wireless or one wireless receiver that can control 30 single sockets. x One set controls one socket. x One set controls multiple sockets. √ Very strong open to falls This product is designed do CE and FCC certification. √ Magnetic protection The panel switch can be turned from scratch and turned into a remote control, making it convenient for the elderly and children. The panel can be magnetically applied do the base or metal object, e.g. refrigerator door. The base can be connected do the wall using a double-sided configuration (included) or screws (included). √ Low losses, extension The lifespan of the master key is 100 000 times. Switching is very energy efficient. Using 2 CR2016 batteries (included), they can be used more than 7000 times normally. Operating Voltage: AC 85V-245V Maximum current: 16A Maximum load: 3300 W RF Frequency: 433 MHz Operating temperature: -30-and80 Reception Sensitivity: andgt; 97dbm Number of remote controls do storage: about 30 pieces Encoding: 1527 Tilted code RF Operation Mode: ASK Superheterodyne Wireless Reception Reception range: The open space is more than 150 meters Size: 50 x 50 x 80mm pilot Encoding: 1527 Tilted code Remote distance: do 50 m (theoretical distance) Radio Frequency: 433 MHz Size: 60 x 30 x 13mm -Opinion: -Snap mode: "ON" button on the panel to turn on the device, then "OFF" button on the device to turn off. -Clear date: Press and hold until the light flashes several times, then release the weapon. success. -Configure -Snap Mode: 1. Press and hold the button until the light lights up and flashes once, then release the weapon. 2. Press the “ON” button on the remote once, the start light flashes and lights up 3. Then press the “OFF” button on the remote once. Success.