B85AL DDR3 Mainboard Dual Channel 3 Phase Power Supply ATX Mainboard PC Gaming Motherboard Support for LGA 1150 CPU Item Type: DDR3 Mainboard Material: PCB Applicable Chipset: B85 Motherboard Architecture: ATX Motherboard Size: Approx. 225 x 175mm / 8.9 x 6.9in CPU Slot Type: Support for LGA 1150 (Support for Intel 4th Generation 1150 pin for i3, i5, i7 and for Celeron Processors) Network Card: Gigabit Network Card Graphics Card Slot: PCIE X16 Gen 3.0 Support Memory Type: 2xDDR3 Maximum Memory Capacity: 8GBx2 SATA Interface: SATA3.0x3 USB Interface: USB3.0x2, USB2.0x2, Front USB2.0 Pins x2, Front USB3.0 Pins x1 Expansion Interface: HD Multimedia Interfacex1, VGAx1, PCIE 1X Expansion Slot, M.2 high Speed Hard Drive Interface, PS/2 Mouse and Key Interface Power Supply: Three Phase Power Supply Battery Type: CR2032 Button Cell (Ship with Inbuilt Battery) Battery Capacity: 240mAh Fix the motherboard in the main case, and then connect the connectors according to the corresponding mark. No power on problem: When the device won't power on and the power indicator doesn't light up, make sure the power supply is connected and working properly. If your CPU fan is installed correctly, you can also determine whether the power supply is working properly by judging whether the fan can work properly. 1. Confirm the power supply of the power adapter a. Please check the connection of the power cord and whether the socket is plugged in as shown in the figure below. If there is a main power switch on the extension cord, please make sure it is on state. b. Replacing the extension cord and socket will help solve the problem. Verify that the motherboard power supply is properly connected: 1. Make sure the poweradapter's power cord is properly plugged into the ATX power connector. The motherboard may contain 24pin EATXPWR and 8pin EATX12V, make sure that both 8pin EATX12V and 24pin EATXPWR are connected to the power adapter. The location and number of powerconnectors may vary by model, some motherboards may contain 24pin EATXPWR and 4pin EATX12V, both connectors should be linked to the power adapter Does not power on: When the fan and Q LED indicator/Q CODE do not respond when the power button is pressed to start the computer, please follow the instructions below to troubleshoot the problem 1. Follow the troubleshooting steps above to confirm that the power adapter is properly plugged into the ATX power connector for the motherboard's power supply 2. Keep the CPU, CPU cooler fan and a separate RAM display on the motherboard. Remove all USB devices and external cards from the motherboard, including mice, keyboards, card readers, flash drives, external hard drives and external PCIE cards, etc. Remove all cables from the motherboard, including network cables, audio cables and display cables (HD Multimedia Interface/VGA/DVI/DP). Then try to turn on the computer, if it turns on properly maybe the problem comes from the external devices removed. Reconnect the external devices one by one until you determine which external device or cable is causing the problem 3. Try to clear the CMOS