Made of high quality material. Increase the authenticity of your RC car. Make your RC car more cool and attractive. Great choice for your RC Car decoration. Come with LED Lights, yellow light. Suit for 1/10 Axial SCX10 RC Crawler Car. Specification: Item Name: Rearview Mirror LED Light Voltage: 4.8V~6V Weight: 60g Installation Steps: 1. Remove the original rearview mirror. Then insert the wire of the rearview mirror into the original hole. 2. Remove the plastic shell on the terminal wire with a blade, and then insert the terminal wire into the hole in the middle of the two round fittings. Pay attention to the direction of the round fittings, with the concave facing the outside of the car door and the flat facing the inside of the car. 3. In the above steps, after threading the thread, cut the hole on the door. cut off about 3mm from top to bottom. 4. After cutting, install the screws. Do not install the screws too tightly. Because it is a 3D printing material, it can't be subjected to too much force and 't loosen. Then replace the original plastic terminal housing. 5. Finally, turn on the 4.8V~6V power supply, or connect to the reserved channel of other lamp groups. In the process of routing, it may be necessary to cut the interior trim panel. This needs to be tailored according to the individual's own situation. colour: black Material: composite material Package Contents: 4 x Rearview Mirror with LED Lights Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.