1000ml Photosensitive Printing Resin Light Curing Universal Rigid Resin for DLP LCD 3D Printer Green Item Type: 3D Printing Resin Capacity: 1000ml Applicable Light Source Wavelength: 365-405nm Underlayer Exposure Time: 20-30S Bottom Layers: 6 layers Regular Exposure Time: 1.5-3S Density: 1.10-1.12g/cm³ Viscosity: 260-350mPa·s (at 25℃) Bending Strength: 47-50Mpa Tensile Strength: 48-54Mpa Hot Deformation Temperature: 85℃ Glass Transition Temperature: 100℃ Shore Hardness: 82D Fracture Elongation: 8%-12% Note: 1. The ambient temperature is 20-30 ℃. Do not print in the window or other environment exposed to ultraviolet light and try to isolate children and pregnant women. 2. Shake the resin for one to two minutes before use to prevent the components from settling. 3. It is recommended to wear nitrile gloves and protective mask when using, and keep indoor ventilation. Those who are allergic to acrylic acid should be cautious. 4. The residual liquid on the surface of the printed resin parts should be cleaned, and the cleaning process should not exceed 1 minute. If the cleaning time is too long, the structural performance of the resin parts will become worse. 5. Where the pores and other details are not easy to clean, ultrasonic or syringe and other auxiliary tools can be used for cleaning, and it is not advisable to clean the model too many times. The cleaning model with impure detergent will lead to whitening and unclean washing. The specific cleaning time shall be subject to the effect that there is no viscosity on the surface of the resin part and no residual resin in the pores. 6. After cleaning, drain or blow dry the residual detergent with a hair dryer, and place it under ultraviolet light or sunlight, and all parts of the model should be evenly exposed to the light, until the surface of the nail scraped resin parts feels dry and the hardness is enough, the residual resin solution on the skin can be cleaned with detergent, and try not to touch the washed resin residue solution with your hands. 7. If you accidentally let the resin enter your eyes or mouth, please wash it with plenty of water immediately. If you feel unwell, please consult a doctor immediately. 8. Product contact with skin may cause maladjustment or allergic symptom. The product may cause serious discomfort if dropped into the eyes. Prolonged exposure to the product environment may cause poor breathing. Eating the product by mistake may cause respiratory discomfort or allergic symptom. Please do not let children contact this product.