Made of high-quality materials, sturdy and durable. BEC 9V /12V output,Designed for Video mitter, Camera, Gimbal ectBEC 5V output,Designed for Flight controller, Receiver, OSD, Camera, Buzzer, 2812 LED_Strip, Buzzer, GPS module, AirSpeedBEC Vx output,Designed for ServosMCU: STM32F405RGT6, 168MHz , 1MB Flash; IMU: ICM42688-P; Baro: DPS310; OSD: AT7456E; Blackbox: Micro-SD card slot6x UARTs, 1x Softserial_Tx option(INAV);10x PWM outputs; 2x I2C; 3x ADC (VBAT, Current, RSSI) Built in inverter for SBUS inputUSB Type-C(USB2.0)FC FirmwareArduPilot: MatekF405-Wing (ArduPlane 4.4 or newer)INAV: MATEKF405SE (INAV 6.0 or newer)PDBInput voltage range: 9~30V (3~6S LiPo) w/TVS protectionCurrent Senor: 220A, 3.3V ADC (INAV scale 150, ArduPilot 66.7A/V)Sense resistor: 100A continuous, 220A peakBattery Voltage divider 1K:10K (Scale 1100 in INAV, BATT_VOLT_MULT 11.0 in ArduPilot)BEC 5V outputDesigned for Flight controller, Receiver, OSD, Camera, Buzzer, 2812 LED_Strip, Buzzer, GPS module, AirSpeedContinuous current: 2 AmpsBEC 9V /12V outputDesigned for Video mitter, Camera, Gimbal ect.Continuous current: 2 Amps12V option with Jumper padfor stable 9V/12V output, input voltage should Greater than output voltage +1VBEC Vx outputBEC 3.3V outputDesigned for external 3.3V peripheralsLinear RegulatorContinuous current: 200mA(Due to different batches, the printed words on the product will be different, which does not affect use)Material: PCBcolour: Blue Package Contents:1 x F405-Wing-V21 x 20cm JST-GH-4P to JST-GH-4P Cable1 Set x Dupont 2.54 Pins (Board is shipped unsoldered) Only the above package content, other products are not included.Note: Light reflection and different displays may cause the color of the item in the picture a little different from the rea