Flexible steel plate with high chromium content, easy to bend and clean. Easier to remove prints and avoid damage, especially for small prints. Re-level the bed. Adjust the Z limit switch after installation. It should be 2.7mm higher, meaning the printing height will be reduced by approximately 2.7mm. A spacer can be printed to compensate for the difference. The magnetic base provides strong magnetic force for a secure fit with the steel plate. The 3M adhesive offers high viscosity and reliable bonding performance at low temperatures, ensuring the base remains firmly attached to the platform. Two easy-lift tabs (handles) allow for simple removal of the steel plate from the magnetic base. The spare steel plate enables continuous printing, allowing you to restart printing while cleaning the first plate, saving time. Clean the build plate with alcohol to ensure no resin or dust remains on the surface. The build plate must be clean and dry. Carefully apply and press the magnetic base onto the build plate to eliminate bubbles, as trapped air may cause the base to peel off. Wait 72 hours after installation before printing. Tip: After installation, use a hair dryer to evenly apply warm air to the magnetic base for 5–10 minutes to enhance adhesion. Size: 140 x 84 mm Package includes: 2 x Flexible Steel Plate, 2 x Magnetic Base Sticker