1. Compared to other similar products, this product uses four-sided flat pressure instead of multi-point pressure, accurate positioning, avoids capacitors, and is good for CPU fixation; 2. The contact surface with the motherboard is a flat bottom, and LOTES insulation protection pads of the same specification are used to reduce the pressure on the motherboard and further reduce signal interference; 3. The metal side is raised to reduce signal interference on the motherboard side; 4. Anodized sandblasting is made of precision-machined aluminum alloy; 5. This product only supports 12th generation CPU, the motherboard CPU socket is LGA1700 chipset is H610 B660 Z690 series. Weight: main body 20g Installation Process: 1. Place the motherboard horizontally on the desk and open the CPU clip 2. Use the included T20 Torx screwdriver to remove the top part and install the bottom bracket 3. Place the CPU into the socket 4. Cover the enhanced buckle on the CPU's top cap and move it slightly until it clicks into place 5. Tighten the screws a half turn on the opposite corners. Each screw takes turns a half turn and a half turn in a diagonal order until the screw is on. will put pressure on the CPU unevenly Color: Red Material: Aluminum Alloy Size: 70 x 54 x 6 mm Package Contents: 1 x LGA17XX-BCF CPU Bending Corrector 1 x L-shaped screwdriver 1 x TF7 Only the above package contents, other products are not included. Note: Light and different displays may cause the color of the item in the picture to be slightly different from the real thing. The allowed measurement error is +/- 1-3 cm.